Features:

• New Design! FTDI Chipset based design +Compatible ELM327 chipset
  
• Works excellently with Scantool 1.13/1.08de versions 
• Works Scan master 1.1-1.7 

• OBDII Plug:    J1962 16-Pin Male (to Car)
• USB Port    :    (to Computer or PDA)
• Length OBD2 cable     :   1.5 meters 
• Weight (set)     :    About 380g
• Color       :    Black cable

•  Scantool software:
  • : ScanTool.net OBD-II software, Ver. 1.13 /1.08de

    ScanTool.net v1.10 (DOS/Windows)

    : PCMScan for Windows (Ver. 1.0) or PCMSCAN

    : ScanMaster Pro for Windows (Ver. 1.0)

     ScanMaster v1.1 for Elm Scan 5 (Demo) or ScanMaster-ELM

    : WGIobdii (Ver. 3.4a)

    : DigiMoto for Window (Ver. 3.7)

    : DigiMoto for Pocket PC (Ver. 1.0)

Will This ELM Work with My Car?(MUST READ)

A small number of 1994 and 1995 model year gasoline vehicles are OBD II compliant. To verify if a 1994 or 1995 vehicle is OBD II compliant, check the Vehicle Emissions Control Information (VECI) Label which is located under the hood or by the radiator of most vehicles. If the vehicle is OBD II compliant, the label will designate “OBD II Certified”. Additionally, Government regulations mandate that all OBD II compliant vehicles must have a “common” sixteen-pin Data Link Connector (DLC).

For your vehicle to be OBD II compliant, it must have a 16 pin DLC (Data Link Connector) under the dash and the Vehicle Emission Control Information Label must state that the vehicle is OBD II compliant. This label is located on the inside of the hood on most vehicles.

VEHICLE COVERAGE
GM '96 - Current Year (OBD-II)
Ford '96 - Current Year (OBD-II)
Chrysler '96 - Current Year (OBD-II)
Toyota '96 - Current Year (OBD-II)
Honda '96 - Current Year (OBD-II)
NISSAN '96 - Current Year (OBD-II)
All other Asian and European '96 - Current Year (OBD-II )

• For laptops and PCs, download the shareware scantoo_net
• Run it and follow the prompts to allow it to install itself.
  Note: You must install software on your PC's hard disk -- it will not work properly if you try running it directly from a floppy or CD. However, you can use a floppy or CD to move the distribution file from a PC with internet access to another PC that does not have internet access.
• Connect the interface between the computer and the car by plugging one end of the interface into a Serial (RS232) (or USB port ) on your PC and the other end directly into the OBD-II port present in all 1996 and newer OBD2 passenger vehicles.
  
• Turn the car's ignition switch ON. No need to start the engine.
• Start the  software program, click "Options", select the correct communications port. Use "Test" to confirm that the program can use the port and find the interface. Then "Save".
• Now it works. Make sure the software can reliably access all the control modules that it should in your car.

Read diagnostic trouble fault codes, both generic and manufacturer-specific, and display their meaning (over 3000 generic fault code definitions in the database). · Clear fault trouble fault codes and turn off the MIL ("Check Engine" "Service soom"light) · Show current sensor data, including: o Engine RPM o Calculated Load Value o Coolant Temperature o Fuel System Status o Vehicle Speed o Short Term Fuel Trim o Long Term Fuel Trim o Intake Manifold Pressure o Timing Advance o Intake Air Temperature o Air Flow Rate o Absolute Throttle Position o Oxygen sensor voltages/associated short term fuel trims o Fuel System status o Fuel Pressure

A PC running Windows: It is recommended to use at least a Pentium-100 (or AMD equivalent) with 16MB of RAM and Windows 95 or newer.  software may work on some lesser PC's, but anything less than the above recommendation is unsupported. Windows 95, 98, ME, NT4, 2000, and XP are all fine. Available disk-space is a total non-issue, software requires less than 1 MB.

1. PayPal is preferred. Other payment methods are also acceptable: Money Order, Cashiers’ Check, and personal check. Delivery will take longer for check’s clearance if payment is made by personal check.
2. Payment is due within 10 calendar days from the end of the auction!! Unpaid items will be reported to Ebay Resolution Center and Negative feedback is going to be left.
3. Full refund of the product purchase cost is guaranteed if returned within 30 days after item(s) delivered and buyer pays for the return shipping.